Interpret Post Fault Messages - Sun Oracle SPARC T3-2 Service Manual

Note – The server takes about one minute to power off. Use the show /HOST
command to determine when the host has been powered off. The console will display
status=Powered Off.
4. Switch to the system console to view the POST output.
-> start /HOST/console
5. If you receive POST error messages, follow the guidelines provided in the topic
"Interpret POST Fault Messages" on page
Related Information
"POST Overview" on page 45
■
FIGURE: Flowchart of ILOM Properties Used to Manage POST Operations on
■
page 47
"Configure How POST Runs" on page 48
■
"Interpret POST Fault Messages" on page 50
■
"Clear POST-Detected Faults" on page 51
■

▼ Interpret POST Fault Messages

1. Run POST.
See
2. View the output and watch for messages that look similar to the following
syntax descriptions and example:
■
■
50 SPARC T3-2 Server Service Manual • December 2013
"Run POST With Maximum Testing" on page
POST error messages use the following syntax:
n:c:s > ERROR: TEST = failing-test
n:c:s > H/W under test = FRU
n:c:s > Repair Instructions: Replace items in order listed by
H/W under test above
n:c:s > MSG = test-error-message
n:c:s > END_ERROR
In this syntax, n = the node number, c = the core number, s = the strand number.
Warning and informational messages use the following syntax:
INFO or WARNING: message
50.
49.