Sun Oracle SPARC T3-2 Service Manual page 104

5. At the Oracle Solaris prompt, type the cfgadm -al command to list all drives
in the device tree, including any drives that are not configured:
# cfgadm -al
The replacement drive is now listed as configured, as shown in the following
example:
Ap_Id
c0
c0::dsk/c1t0d0
c0::dsk/c1t1d0
usb0/1
usb0/2
.
.
.
6. Perform one of the following tasks based on your verification results:
■
■
For additional drive verification, you can run SunVTS. Refer to the SunVTS
documentation for details.
92 SPARC T3-2 Server Service Manual • December 2013
Type Receptacle
scsi-bus connected
disk connected
disk connected
unknown
unknown
If the previous steps did not verify the drive, see
page 16.
If the previous steps indicate that the drive is functioning properly, perform the
tasks required to configure the drive. These tasks are covered in the Solaris OS
administration documentation.
Occupant Condition
configured unknown
configured unknown
configured unknown
empty unconfigured ok
empty unconfigured ok
"Diagnostics Process" on