Sun Oracle SPARC T3-2 Service Manual page 192

3. Prior to powering on the server, connect a terminal or a terminal emulator (PC
or workstation) to the service processor SER MGT port.
Refer to the SPARC T3-2 Server Installation Guide for instructions.
If the replacement service processor detects that the service processor firmware is
not compatible with the existing host firmware, further action will be suspended
and the following message will be displayed:
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
version that supports this chassis.
If you see the preceding message, continue to the next step. Otherwise, skip to
Step
4. Download the system firmware.
a. Configure the service processor NET MGT port so that it can access the
b. Download the system firmware.
Note – You can load any supported system firmware version, including the
firmware version that was installed prior to replacing the service processor.
c. If you created a backup of your Oracle ILOM configuration, use the ILOM
5. Power on the server.
See
6. Verify the service processor.
See
Related Information
Oracle ILOM documentation
■
"Remove the Service Processor" on page 176
■
"Verify Service Processor Functionality" on page 181
■
180 SPARC T3-2 Server Service Manual • December 2013
5.
network, and log in to the service processor through the NET MGT port.
Refer to the Oracle ILOM documentation for network configuration
instructions.
Follow the firmware download instructions in the Oracle ILOM documentation.
restore utility to restore the configuration of the replacement service
processor.
Refer to the Oracle ILOM documentation for instructions.
"Power On the Server" on page
"Verify Service Processor Functionality" on page
198.
181.