Table of Contents
Advertisement
Service Processor Firmware and
Configuration
System firmware consists of two components: a service processor component and a
host component. The service processor component is located on the service processor
and the host component is located on the motherboard. In order for the system to
operate correctly, these two components must be compatible.
When replacing the service processor, you must restore the configuration settings
maintained in the service processor. Before replacing the service processor, save the
configuration using the Oracle ILOM backup utility. Refer to the Oracle ILOM
documentation for instructions on backing up and restoring the Oracle ILOM
configuration.
After replacing the service processor, the new service processor firmware component
must be compatible with the existing host firmware component. If the firmware
components are incompatible, load new system firmware as described in
Service Processor" on page
Related Information
Oracle ILOM documentation
■
"Servicing the Motherboard" on page 163
■
"Remove the Service Processor" on page 176
■
"Install the Service Processor" on page 179
■
▼ Remove the Service Processor
Caution – Ensure that all power is removed from the server before removing or
installing the motherboard assembly. You must disconnect the power cables from the
system before performing these procedures.
176
SPARC T3-2 Server Service Manual • December 2013
179.
"Install the
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARC T3-2 and is the answer not in the manual?
Questions and answers