Programming Memories with Parts
Spots, channels, and selected spot parameters can be assigned to Parts during the initial
memory programming. Existing memories can be divided into Parts.
Programming a Part with spots
Example: Assign spots 1 - 5, in their entirety, to Part 1.
Keypresses
1. Select spots and assign
parameter values.
Æ
2. Select spots 1
5 and
assign parameter values.
3. Press [PART] [1]
4. Press [TIME] [3]
5. Press [WAIT] [2]
6. Press [=] [1]
7. Press [STORE]
Programming a Part with spot parameters
Specific spot parameters can be assigned to Parts
Example: Assign parameter 6 of spots 1 - 5 to Part 1.
Keypresses
Æ
1. Select spots 1
5.
2. Select parameter 6 and
assign a value.
3. Press [PART] [1]
4. Press [TIME] [3]
5. Press [WAIT] [2]
6. Press [=] [1]
7. Press [STORE]
Programming Memories with Parts
Results/Comments
A green dash is displayed next to all of the
parameter values in the selected spots.
The message Memory 1 Stored is displayed.
Results/Comments
Assign the selected parameter to Part 1. A green
dash is displayed next to the selected
parameters.
Assign a fade of 3 counts to the selected
parameter in Part 1.
Assign a wait time: the amount of time Part 1 will
wait before commencing its fade.
The message Memory 1 Stored is displayed.
21-3
Sabre