Table of Contents
Advertisement
Assigning a value to a discrete step using the numeric keypad
Example: You have selected Superscan Zoom E's gobo wheel (parameter 6). You want to
assign step 2.
Keypresses
1. Select spots.
2. Press a Parameter key.
3. Press 2 on the keypad.
Using the Step keys
Keypresses
1. Select spots.
2. Press a Parameter key.
3. Press [STEP UP] or
[STEP DOWN]
Assigning values for mixed steps
Discrete steps with continuous control between the steps.
Example: Superscan Zoom E's dimmer control channel controls both the dimmer and the
shutter (strobe). Sabre controls this as 2 mixed steps; step 1 and the continuous control
within step 1 controls the dimmer and step 2 controls the strobe rate.
Mixed steps are displayed in #.# format; step 1 at 60% is 1.6, step 2 at full is 2.f. The
number after the decimal point represents the percentage of the step; each step has a range
from 0 to full. The actual percentage of the parameter control channel range is defined in
the Mix Output menu.
[STEP UP] and [STEP DOWN] moves from step to step. Within each step there is
continuous control via the parameter wheel.
Assigning a mixed step value using the numeric keypad
Example: assign step 2 at full to Superscan Zoom E's color wheel parameter (p14).
Keypresses
1. Select spots.
2. Press a Parameter key.
3. Press [2] [•] [FULL]
Spot Parameters
Results/Comments
Enter a double digit (02, in this case) if there
are more than 9 steps defined.
Results/Comments
The selected parameter appears in brackets
on the LCD display, the LED of the key
blinks, and the parameter name is shown
spot display in dark red.
Each press on these keys either increments
or decrements the current value by 1 step.
Results/Comments
The selected parameter appears in brackets
on the LCD display, the LED of the key
blinks, and the parameter name is shown in
red on the spot display
The parameter value for p14 shows
5-13
2.f
.
Sabre
Advertisement
Table of Contents
