Compulite Sabre User Manual page 344

The steps below assign yokes, whose external dimmers are dimmers 100 and 101, to spots
5 and 6.
Step 1 - Defining a yoke
Keypresses
1. Press F2 Select Device
2. Place the cursor on the space
you have reserved for the
yoke definition.
3. Press F5 Define Device
4. Type:
Yoke, Yo,
5. Use the procedure described
above to define the x and y
parameters.
6. Move the cursor to parameter
DM .
7. Type: 99
8. Define the rest of the
parameters
9. Press F1 Store
Step 2 -Assigning spot numbers
The next step is to patch the unit to a spot number.
Keypresses
1. Press F2 Select Device
2. Press the arrow keys and
Select "yoke".
3. Press F4 Select Spot #
4. Using the example above,
enter 5 on the keypad.
5. Press F2 Thru Spot #
6. Using the example above,
enter 6 on the keypad.
7. Press F1 Store
Mix Output Menu
Results/Comments
The definition table field turns red.
Identify yoke as a new device. The label is yo.
Identifies this parameter as an external
dimmer.
At this point you may want to also store the
device in the User's device pool. (See Error!
Reference source not found., page Error!
Bookmark not defined.)
Results/Comments
Spot numbers 5 and 6 control yokes.
27-17
Sabre