Operating Leader - Compulite Sabre User Manual

25-8

Operating Leader

Assigning a relative delay (spatial display)
Keypresses
1. Select a spot or a range of
spots.
2. Press [WAIT]
3. Enter a numerical value in
response to the prompt.
4. Press [STORE]
Canceling the delay assignment
Keypresses
1. Select spots
2. Press [TIME [0]
3. Press [STORE
Operating Leader
If you use the Leader function frequently, it is handy to make Macros for the Leader enable
and disable functions, providing yourself with single keypress access.
Enabling Leader function
When you store a leader assignment, the leader function is automatically enabled. If the leader
spot is assigned to any active playback device or is selected in the editor, the follower spots'
x/y values are displayed on a green field.
Keypresses
1. Press [LEADER]
2. Press [+]
Disabling Leader
The leader function need not be used throughout the show. It can be disabled at any time.
1. Press [LEADER]
2. Press []
Results/Comments
If the current display was not the leader table, it is
now displayed. The prompt in the command line
reads: Spot # Rel. Delay:
The value is a percentage of the cycle of the
effect.
The percent of delay assignment appears next to
the follower spot number on the leader display.
Results/Comments
The Leader display is shown.
The leader information on the Stage display is
shown in red.
The Leader display is shown.
The leader information on the Stage display is
shown in gray.