Inserting A Memory; Programming A Blackout Cue - Compulite Sabre User Manual

7-20

Inserting a Memory

Inserting a Memory
To insert a memory, create a lighting state and record the new memory with a sub-decimal
number. Nine (9) memories may be inserted between each whole number memory.
Example: Insert a memory between memories 3 and 4.
Keypresses
1. Create a lighting state.
2. Press [=] or [MEMORY]
3. Enter [3 • 5] on the keypad.
4. Press [STORE]

Programming a Blackout Cue

Program a Blackout cue by recording a memory when the editor is empty. This can be
done in live or blind mode.
Blackout memories are identified as such on the memory list and selected memory exams.
When viewing the memory list, Blackout appears in the text column of the memory list.
When viewing a selected memory, the message This Memory is a Blackout is displayed in
red.
Example: Record memory 8.5 as a blackout.
Keypresses
1. Press [RESET]
2. Press [=] and enter [8 • 5] on
the keypad
3. Press [STORE]
Sabre
Results/Comments
Tip: if the memory being inserted between
memories 3 and 4 is an outgrowth of 3 (for
instance), create your lighting state by using
the sequence [MEMORY] [3] [ENTER] and
then proceed to edit.
Memory appears in the command line.
Memory 3.5 is inserted between memories 3
and 4.
Results/Comments
All spots and channels are cleared from the
editor.