Table of Contents
Advertisement
Returning to memory rate
Turn the rate wheel until MEM is displayed on the playback display.
Keypresses
1. Move the wheel back to the memory
rate.
Configuring the Crossfader
You can configure faders B and D as a crossfader and a rate fader, as split crossfaders, or
disable faders B and D completely.
In this discussion B and D refer to the second fader handle A/B and C/D.
Configure B and D as Rate Faders
Keypresses
1. Go to Service Tools
2. Press F3 System Config
3. Enter the passcode
4. Press F4 Special Functions
5. Place the cursor on bit C B/D Faders and toggle to 0 – Enable.
6. Place the cursor on bit D B/D Faders Usage and toggle to 0 – Rate.
7. Store the change and Cold Start the desk.
Configure as split crossfaders
When the B and D faders are configured as split crossfaders, use the Rate wheels for rate
control.
Keypresses
1. Go to Service Tools
2. Press F3 System Config
3. Enter the passcode
4. Press F4 Special Functions
5. Place the cursor on bit C B/D Faders and toggle to 0 – Enable.
6. Place the cursor on bit D B/D Faders Usage and toggle to 1 – Split.
7. Store the change and Cold Start the desk.
Configuring the Crossfader
Results/Comments
MEM is displayed on the playback display.
12-9
Sabre
Advertisement
Table of Contents
