Table of Contents
Advertisement
5-14
Spot Parameters
Assigning a mixed step value using the numeric keypad
Example: Assign step 2 at full to Superscan Zoom E's color wheel parameter (p14).
Keypresses
1. Select spots.
2. Press a Parameter key.
3. Press [STEP UP] or [STEP
DOWN] until step 2 is
selected.
4. Press [FULL]
Parameter modes for Cyberlight and Intellabeam
Some of the parameters for Cyberlight and Intellabeam have different operating modes.
These parameters are:
•
Static gobo (p6) - Intellabeam and Cyberlight.
•
Shutter (p 8) - Intellabeam and Cyberlight.
•
Effect (p12) - Cyberlight only.
•
Rotating gobo (p13) - Cyberlight only.
•
Color wheel (p 15 for Cyberlight; p2 for Intellabeam).
Static Gobo (p6)
ICON/FUNCTION MODE
〈 (Cyberlight only)
〉 (Cyberlight only)
← direction of gobo wheel rotation
→ direction of gobo wheel rotation
(=) gobo shake (Cyberlight only)
(-) gobo scan (Cyberlight only)
» fast crossfade (jump in crossfade)
≈ proportional crossfade (fade in crossfade).
Shutter (p8)
ICON/FUNCTION MODE
→ strobe speed
<> indicates shutter open
indicates shutter closed
Sabre
Results/Comments
The selected parameter appears in brackets
on the LCD display, the LED of the key
blinks, and the parameter name is shown in
red on the spot display
The parameter value for p14 shows
2.f
.
Advertisement
Table of Contents
