Table of Contents
Advertisement
20-10
Effect Attributes
Default values for Rate, Size, and Delta
Attribute
Rate
Size
Size
Size
Delta
Delta
Offset
Offset controls when a spot begins its action within the time cycle.
The Offset attribute has 5 modes: <Lck> (Lock) <All>, <Spd> (Spread), and <Prt> (Part),
and <Neg> (Negative).
<Lck> Locks the Offset value so that it is not changed when the Rate is changed.
<All> Assigns the identical offset to the selected parameters. If a spread has been assigned
All assignments preserved the proportionality.
<Spd> Assigns a different offset value to the selected parameters; each spot begins the
Effect at a different stage of the time cycle.
<Prt> Assigns automatic spread values to the number of spots relative to the Duty Cycle.
Using Spread
The spread assignment is determined by the K value. The K value is displayed on the LCD
display. The Offset values assigned to the parameters are a function of the K value and the
number of spots.
Example: Pan (X) for spots 1
an offset value of 0, spot 2 is offset 3, spot 3 is offset 6, spot 4 is offset 9.
Æ
The assignment of the spread depends on the order of the spot selection. If the spot
selection was Spot 4
1, spot 1 receives value 9, spot 2 value 6, spot 3 value 3, and spot 4
value 0. In other words, spot 4 is the leading spot.
Sabre
Parameter Type
Continuous parameters, including channels
Discrete step parameters, including
scrollers
Mixed step parameters
X and Y
Continuous parameters, including
channels. Not including X and Y
X and Y
Æ
4 is selected. The Spread K value is 3. Spot 1 is assigned
Default
200
FL
0 (zero)
50
Top - If the Base
value ≤ 50.
Bottom - If the Base
value is > 50
Center
Advertisement
Table of Contents
