Copying A Spot Position - Compulite Sabre User Manual

5-18 Spot Parameters

Copying a spot position

Only spots that have been set up in the Leader menu are eligible for this function. See
Chapter 25 - Leader
Copy spot position provides an easy method of moving a spot to the same position as
another spot.
This function can greatly enhance editing speed. To fully utilize this function make this
Macro: [COPY] [LEADER].
Keypresses
1. Select spots.
2. Trackball
3. Press [COPY]
4. Select the spot being copied.
5. Press [LEADER] (in editor
section, not the NSK mode)
6. [#] (optional)
7. Press [ENTER]
Sabre
Results/Comments
Select one of the spots that has been
initialized in the leader set up.
Move to the desired position.
Select the copy function. Copy from appears
in the command line.
If no spot number is selected the system
assumes the last selected spot. Example: if
the sequence was [SPOT 3] [TB] [SPOT 5]
[COPY] [LEADER], the system assumes it
is copying the position of spot 3.
The selected spots jump to the target
position.