Configuring The System For Midi - Compulite Sabre User Manual

29-2

Configuring the System for MIDI

Configuring the System for MIDI
To configure Sabre for MIDI communication, you must enable the bits A and K in the
Special Functions configuration under Config Sys in Service Tools. You must also define
the MIDI communication channel in the System Parameters menu.
Keypresses
1. Go to Service Tools.
2. Press F3 Config Sys.
3. Enter the password.
4. Press F4 Special Functions
5. Press F1 Toggle
6. Press F2 Down until the
cursor is on Bit K Internal MIDI
7. Press F1 Toggle
8. Press F6 Enter & exit
9. Press F6 Store
10. Turn off Sabre and switch it
back on.
11. Press F1 Cold Start
12. Press [MENU]
13. Press 8 [ENTER]
14. Use the arrow keys on the
Sabre and move the cursor to
MIDI i/o channel.
15. Press F1 Enter
Sabre
Results/Comments
The cursor should be on Bit A MIDI.
Bit A is now toggled to Enable .
Bit K is now toggled to Yes
The main Config Sys menu is displayed. A
confirmation request is displayed.
Sabre now boots up. After major changes
in the system configuration it is necessary
to power down and power up again.
The system exits Service Tools and comes
up in editor mode.
The menu list is displayed.
You are now in the System Parameters
menu.
Enter the MIDI communication channel
(channels 1 - 16).