Compulite Sabre User Manual page 334

Using the auto set up option
When the selected spots are High End or S-Mix devices, Sabre distributes the assignments
to connectors. Remember! High End devices are limited to 24 per connector.
Keypresses
1. Press F1 Set Address
2. Press F5 Auto Setup
3. Press F1 Best Fit
4. Press F1 Store
Assigning a default space
Keypresses
1. Press F1 Set Address
2. Press F5 Auto Setup
3. Press F2 Default Space
4. Select the number of DMX
channels that will be
apportioned to all of the
spots.
5. Press F1 Store
6. Press F1 Store
Enabling/disabling spot output
You can disable a spot's output from the console. This is useful in case a spot is
malfunctioning, avoiding physically disconnecting the psychotic device. Any spot disabled
via the console can be enabled again.
Keypresses
1. Press F1 Set Address
2. Press F1 Select Spot(s)
3. Press F2 Disable
or
Press F3 Enable
Mix Output Menu
Results/Comments
A warning message is displayed: All Output
Setup Will Be Changed!
The DMX or S-Mix/High End addresses are
now displayed in the output row of the
assignment table. The updated connector
assignments are also displayed.
Results/Comments
You are prompted to enter the default output
length that will be assigned to all spots.
The message: All Output Setup Will Be
Changed! is displayed.
The DMX addresses are now displayed in the
output row of the assignment table.
Results/Comments
A range of spots can be selected using the key
sequence [# → #].
The output address of a disabled spot appears
on a gray field.
27-7
Sabre