Table of Contents
Advertisement
20-22
Playing Back Effects
Playing Back Effects
On the Crossfaders
Memories or groups containing Effects can run on the crossfaders. When the incoming
memory has an Effect it begins running on the Go command.
On the Controllers
When the grp or memory assignment is in XF mode, moving the controller lever fades all
the parameters participating in the Effect from tracking or stage.
When the grp or memory assignment is Dim mode, the controller level controls the dimmer
of the participating spots. The Effect is constantly running.
You can gain control of the overall Effect rate when effects are running on Controllers. The
controller's [GO] key increases the rate. The controller's [HOLD] key decreases the rate.
Modifying the rate
Keypresses
1. Press [CHASE RATE]
2. Press [GO] or [HOLD] to
modify the Effect Rate.
3. Optional- store the modified
rate by pressing [STORE
RATE]
Mirror Effect
You can switch the rate between hold and a mirror effect. The mirror effect is the same as
assigning a negative rate. The Mirror Effect runs at the memory rate unless you modify it.
Keypresses
1. Press [CHASE RATE]
2. Press and hold [SHIFT] and
press [GO]
3. To modify the –MEM rate press
[GO] to increase the rate or
[HOLD] to decrease the rate.
Sabre
Results/Comments
The LED is on, indicating that the Chase
Rate function is active.
The modified rate is displayed on the
controller LCD display. The proportionality of
the Rates assigned to different parameters in
the Effect is preserved.
The message Effect Rate Stored is
displayed.
The Effect runs at the stored rate whenever it
is assigned to a controller. The original rate
is, however, not overwritten. If you run the
Effect in the editor or on the crossfaders, it
runs at its original rate.
Results/Comments
The LED is on, indicating that the Chase
Rate function is active.
Toggles between + rate and – rate.
Advertisement
Table of Contents
