Compulite Sabre User Manual page 418

Key
[PART]
[PILE ON]
[POSITION]
[PRIO]
[Q-KEY]
[Q-LIST]
[RATE A/B]
[RATE C/D]
[RATE CHASE]
[RELEASE]
[REM DIM]
[RESET]
[S1] [S2]
[SEQ] (A/B)
What it does
Memories may be divided into up to 9 parts. Each part can have its
own fade and wait times.
Toggle the fade mode for Q-Keys. When active (LED on) the fade
mode is additive - each Go adds the Q-Key assignment to the
current lighting state. When inactive (LED off) each Go initiates a
crossfade between the current Q-Key output and the incoming Q-
Key assignment.
Program, access, and erase Position Libraries on the Numeric Soft
Keys.
Enable or disable the LTP control priority.
Change or store priority maps.
Switch the Numeric Soft Key mode to Q-Key.
There are 2 [Q LIST] keys.
One is located in the editor section; it is used to preface Q-List
selections.
The second [Q LIST] key switches the NSKs to Q-List mode.
When active (LED on), the Rate Wheel modifies the crossfade rate
on the A/B crossfader.
When active (LED on), the Rate Wheel modifies crossfade rate of
the C/D crossfader.
When active (LED on), pressing [GO DIM] and [HOLD XF]
modifies the chaser rate.
Release spots, spot parameters, channels, and scrollers from
memories, the editor, Libraries, and controller assignments.
Black out all dimmer output except the selected spots or channels
(displayed in red in the editor).
Press a second time to return output.
Clear the editor of all active channels and spots that are under
editor control, putting the editor in idle.
Return to live mode from Menu mode.
Inhibit submasters. Any spot, channel, or memory may be directly
assigned to either Submaster.
These Submasters can also submaster the A/B or C/D crossfaders.
This function is assigned through the System Parameters menu.
When activated (LED on), the next memory in the numerical
sequence is automatically loaded into the crossfader at its zero
limit.
B-9
Sabre