Table of Contents
Advertisement
27-6
Mix Output Menu
converter for the Martin devices and a second S-Mix converter for the Intellabeam devices.
The output addresses for the Martins and Intellabeams are determined by the addresses set
on the S-Mix converters, so spot 25 can have output address 1 and so can spot 31.
The set up looks like this:
SABRE
output
connector 5
in
Martin 1 - 16
spots 25 - 30
Assigning addresses to selected spots
When choosing to assign addresses to selected spots, you are prompted to specify the
connector assignment for each spot.
Keypresses
1. Press F1 Set Address
2. Press F1 Select Spot(s)
3. Select spots using the
numeric keypad.
4. Press F1 Start At Con
5. Press F1 Set Address
6. Press F1 Store
7. Repeat from step 5.
8. Exit by pressing F6 Restart
Sabre
thru
in
Hi End 1 - 24
spots 31 - 36
Actions/Comments
A range of spots can be selected using the key
sequence # → #.
The default is connector 1. Change this if
necessary. Note that the connector
assignment for S-Mix spots is always
connectors 4 - 6.
The default is address 1. Change this if
necessary.
After pressing store, Sabre automatically
advances to the next spot keeping the same
connector assignment.
When you press F1 Set Address the DMX or
S-Mix address is entered according to the
output length of the spot.
Advertisement
Table of Contents
