Table of Contents
Advertisement
Assigning Spots
If no parameter values are entered, the current parameter values (current output or
tracking) of the selected spots are the values included in the controller assignment.
Assignments depend on the editor status. When the editor contains selected (displayed in
red) and active spots (displayed in white) only the active spots are included in the
controller assignment. If the editor contains active spots, but no selected spots all spots in
the editor are assigned.
Æ
Example: Spots 1
6 are in the editor. You then select spots 10
a controller will include spots 10
you must press [ENTER] before the assignment sequence.
Assigning a range of spots to a controller
Æ
Example: Spots 1
6 are selected in the editor. Assign them to controller 6.
Keypresses
Æ
1. Select spots 1
6.
2. Optional − assign parameter
values to the selected spots.
3. Press [ASSIGN]
4. Press [XF] or [DIM]
Æ
Example: Spots 10
16 are selected in the editor. Spots 1
Assign the editor contents to controller 6.
Keypresses
Æ
1. Select spots 1
6.
2. Optional − assign parameter
values to the selected spots.
Æ
3. Select spots 10
4. Optional − assign parameter
values to the selected spots.
5. Press [ENTER]
6. Press [ASSIGN]
7. Press [XF] or [DIM]
Æ
16 only. If you want to assign all spots in the editor,
Results/Comments
The spots are displayed in red.
The message Dim/Fade Key Expected is
displayed.
The controller display and the LCD display
show this assignment as grp .
Results/Comments
Æ
16.
Spots 1
Spots 10
Æ
Spots 1
in white.
The message Dim/Fade Key Expected is
displayed.
The controller display and the LCD display
show this assignment as grp .
Assigning Spots
Æ
16. An assignment to
Æ
6 are active in the editor.
6 are displayed in white.
Æ
16 are displayed in red.
Æ
6 and spots 10
16 are displayed
13-7
Sabre
Advertisement
Table of Contents
