Exiting a automatic or manual continuous Loop
Keypresses
1. Press [GO]
Erasing a Loop assignment
Keypresses
1. Select the first memory of the
Loop
2. Press [LOOP]
3. Press [ERASE]
Erasing an auto follow Loop assignment
This erases the autofollow Loop only, leaving the basic Loop assignment intact.
Keypresses
1. Select the first memory of the
autofollow Loop assignment.
2. Press [LOOP]
3. Press [+]
4. Press [ERASE]
Results/Comments
An immediate crossfade to the memory
following the Loop is initiated. The crossfade
occurs in the recorded memory time.
Results/Comments
Cancels the Loop assignment. The message
Memory # Stored is displayed. If the Loop is
assigned, the message Memory On Board is
displayed; press [ERASE] again to confirm the
command.
Results/Comments
Both Loop assignments remain, but the link
between them is canceled.
Loops
10-5
Sabre