Size - Compulite Sabre User Manual

Size

The Size determines how much movement takes place from the Base. The Size default is Zr
or 50 or Fl depending on the type of parameter.
Example: The Base is 50, Size is 50, Delta is C (center). The range of movement is Base
+25 and Base – 25.
25
Base
50
Figure 2 Size attribute and center Delta
Example: If the Base value is 30, Size 50, and Delta C, the upper value is 55 and the lower
value is 5.
5
Base
30
Figure 3 Size atrribute and center Delta
Changing the Size
Size can be modified absolutely. <All> is the default selection. The same size value is
given to parameter for all selected spots.
The Size modification can be "spread" relatively over the selected parameters in the
selected spots. The assignment of the spread depends on the order of the spot selection.
Keypresses
1. Press <All> or <Spd> under
Size.
2. Use Offset wheel or enter a
value on the keypad.
Assigning a negative size
Keypresses
1. Press [NEG] for Size
75
55
Results/Comments
The LED of the selected key flashes.
The new value is displayed on the monitor and
the LCD display.
Results/Comments
A minus sign precedes the Size value.
Effect Attributes 20-7
Sabre