Chaser Rate - Compulite Sabre User Manual

13-18 Chasers
Changing an assignment from soft run mode to hard
Keypresses
1. Press [HARD]
2. Press [DIM] or [XF]

Chaser rate

The chaser rate is determined by the fade time assignments for each memory included
within the chaser.
In Soft run mode the fades between memories occur in the recorded memory times,
preserving the integrity of all the time assignments - time-in, time-out, delay, wait- in, and
wait-out.
Hard run mode bumps from memory to memory in 1/10 (one tenth) of the time-in
assignment. Example: if the current step is memory 5 and memory 6 the time-in
assignment of the incoming memory is 10 seconds, the time lapse between the bump from
memory 5 to memory 6 is 1 second. .
The Chase rate of each chaser assignment can be modified and if desired stored.
Modifying the chaser rate
[DIM] and [XF] are used to change the chaser rate. Pressing [DIM] increases the chase
rate. Pressing [XF] decreases the chase rate.
Cut and hold are the chase rate limits.
Keypresses
1. Press [RATE CHASE]
2. Press and hold [DIM] or
[XF]
Quick modification sequences
Current Keypresses
Chase Rate
Memory time [SHIFT] [DIM]
[SHIFT] [XF]
[SHIFT] [XF]
Cut
[SHIFT] [XF] [XF]
[SHIFT] [DIM]
Hold
[SHIFT] [DIM] [DIM]
Sabre
Results/Comments
Hard replaces Soft on the LCD display.
Results/Comments
The LCD of the key is lit.
The modified chase rate, in red on a blue field, is
displayed in the controller area of the X-Fade Exam
and on the LCD displays..
What happens
Bumps to Cut.
Bumps to Hold
Bumps to memory
Bumps to Hold
Bumps to Memory
Bumps to Cut.