Table of Contents
Advertisement
20-24
Loading, Recording, and Deleting Effect Files
You can load only some of the Effects contained in the file.
Example: The Effect file contains Effects 1 – 20. You want to load Effects 1
Effect number 1.
Keypresses
1. Go to the Load menu.
2. Press F4 Effect Files
3. Enter the file number at the
prompt.
4. Optional - Press F4 Exam
File or F5 Exam Effects
5. Press F2 Effect #
6. Enter 5 at the prompt.
7. Press F2 Thru Effect #
8. Enter 8 at the prompt.
9. Press F3 To Effect #
10. Enter 1 at the prompt.
11. Press F1 Load
12. Press F1 Yes
You can load Effects to numbers different than appear in the file.
Example: The Effect file contains Effects numbered from 1 – 20. You want to load them as
Effects 21 – 40. When loading this file, you request that the load begin at Effect 21.
Keypresses
1. Go to the Load menu.
2. Press F1 Effect Files
3. Enter the file number at the
prompt.
4. Optional - Press F4 Exam
File or F5 Exam Effects
5. Press F1 All Effects
6. Press F2 To Effect
7. Following the example above,
enter number 21.
8. Press F1 Load
9. Press F1 Yes
Sabre
Results/Comments
Effect files in the current directory are
displayed. If there are Effects already in the
system, they are displayed on CRT 2.
The selection is displayed on monitor 2.
The prompt Effect # to Load: is displayed.
You are prompted for an Effect number.
The prompt Start at Effect # is displayed.
You are prompted to confirm the command.
In Effect mode NSK LEDs for 1
Results/Comments
Effect files in the current directory are
displayed.
This selection is displayed on monitor 2.
The prompt Start at Effect # is displayed.
You are prompted to confirm the command.
In Effect mode NSK LEDs for 21
Æ
8 starting at
Æ
8 are lit.
Æ
40 are lit.
Advertisement
Table of Contents
