Compulite Sabre User Manual page 248

20-12 Effect Attributes
Examples of Offset uses
Example: Program an Effect where 4 spots execute a Cancan.
Keypresses
Æ
1. Select spots 1 4.
2. Press [Y] and assign a value.
That will serve as the Base.
3. Press [EFFECT]
4. Use the Iris wheel and assign
Saw.
5. Press <Spd> for the Offset
attribute.
6. Turn the Offset wheel until
reaching the value 25% or
enter 25 on the keypad.
Using Part
Part assignments appear as absolute numbers in the command line and as percentage on the
LCD display.
Parts work in conjunction with the Duty Cycle. (See below).
Using the example above program the Effect so that spot 1 executes its Effect assignment,
then spot 2, then spot 3, and lastly spot 4.
Keypresses
Æ
1. Select spots 1 4
2. Press [Y] and assign the
parameter value that will
serve as the Base value for
the Effect.
3. Press [EFFECT]
4. Use the Iris wheel and assign
Saw.
5. Change the Duty Cycle to 1:4
6. Press Offset <Prt> and press
4 on the keypad or use the
Offset wheel.
¾ ¾
Note
When spot parameters are assigned a Spread Offset they are always in motion. When spot
parameters are assigned Prt values they move as a groups depending on the Part assignment
and Duty Cycle
Sabre
Results/Comments
The Effect Editor is active. Spots 1
Y is selected, displayed on a red field.
The Offset value assigned to each spot is:
Spot 1 is assigned Offset 0%
Spot 2 is assigned Offset 25%
Spot 3 is assigned Offset 50%
Spot 4 is assigned Offset 75%
Results/Comments
The Effect Editor is active. Spots 1
Y is selected, displayed on a red field.
The Offset value assigned to each spot is:
Spot 1 is assigned Offset 0%
Spot 2 is assigned Offset 25%
Spot 3 is assigned Offset 50%
Spot 4 is assigned Offset 75%
Æ
4 are on.
Æ
4 are on.