Table of Contents
Advertisement
The input and output controllers' display has only 2 columns:
1. Sys - indicating the playback device.
2. MIDI - the MIDI code assigned to the playback device.
The message for input/output controllers is always Control Change.
If control change is assigned to the input/output keys, care must be taken to assure that
there is no duplication of the MIDI code.
Example: If input/output controller A/B is programmed as MIDI 20, do not program
input/output key Hold A/B as control change, data 20.
The example below will use the input keys. The procedure is the same for all of the
options.
Keypresses
1. Press F1 Input Keys
2. use the arrow keys
3. Press F1 Enter
4. Use the → key on the console
to select the column.
5. Press F2 Toggle
or
If you are editing the data
column, enter a number on
the numeric keypad.
6. Press F1 Store
MIDI Macro
This allows creating a macro using MIDI transmission input. The macro collects the MIDI
codes received from a MIDI transmitting source.
Keypresses
1. Press F5 MIDI Macro
2. Press F1 Create Macro
3. Transmit MIDI commands to
console
4. Press F1 Store
Results/Comments
Select the input keys.
Move the cursor to highlight the required key.
You now have access to the selected entry.
Use this key to toggle to the required
selection: note on , note off , control channel
change, N/A .
The new data is stored.
Results/Comments
This selection transports you to the macro
menu.
Select the Create Macro function. The system
will prompt for a macro number
This transmission should contain no more
than 16 commands.
Store the macro. The macro appears in blue
and is a collection of MIDI codes.
MIDI Macro
29-5
Sabre
Advertisement
Table of Contents
