Table of Contents
Advertisement
28-6
Channel Patch
Restoring the default patch
The system boots up with a 1 to 1 default in the Channel Patch.
If soft patching has been done and you wish to restore the Default patch, use this function.
The entire patch table, single dimmers, or a range of dimmers may be restored to the
default patch. The example below demonstrates restoration of the entire patch table.
Keypresses
1. Press F3 Default
2. Press F1 All Patches
3. Press F1 Yes
Exchanging dimmers
Exchanging dimmers swaps the dimmers' channel assignments.
Example: Dimmer 89 is patched to channel 89 and dimmer 90 is patched to channel 56.
Exchanging the dimmers assigns channel 89 to dimmer 90 and channel 56 to dimmer 89.
Keypresses
1. If necessary, press [@] to
toggle the connector.
2. Press F4 Exchange
Dimmers
3. Enter the dimmer number in
response to the prompt
4. Press F1 With Dimmer
5. Enter the number on the
numeric keypad.
6. Press F1 Store
Sabre
Results/Comments
The system asks Are You Sure?
Confirm the command. The entire patch table
will revert to 1 to 1 patch assignments.
Results/Comments
Sabre prompts: Exchange Dimmer #:
Complete the dimmer exchange. The result is
displayed like all other soft patches.
Advertisement
Table of Contents
