Table of Contents
Advertisement
7-14
Fade Times
Assigning fade times to a new memory
Example: Assign fade times to memory 7.
Keypresses
1. Create a lighting state
2. Press [=] [7] to store as
memory 7.
3. Press [TIME] and enter 6 on
the keypad.
4. Press [TIME] and enter 8 on
the keypad.
5. Press [WAIT] [WAIT] and
enter 2 on the keypad.
6. Press [STORE]
If you have neglected to enter the time assignments before pressing [STORE]:
1. Press [TIME] or [WAIT]. The command line displays the last recorded
memory. Enter the desired fade time.
2. Press [STORE] and record the memory with its time assignments.
Assigning fade times to an existing memory
Example 1: Assign a 10-second time-in to memory 1.
Keypresses
1. Select memory 1
2. Press [TIME ]
3. Enter 10 on the keypad.
4. Press [STORE]
Sabre
Results/Comments
Time-i is displayed in the command line. The
incoming spots/channels in memory 3 will
fade up in 6 seconds.
Time-o is displayed in the command line. The
spots/channels fading to a lesser intensity,
when crossfading between memory 2 and
memory 3, take 8 seconds to complete their
fade.
Wait-in is displayed in the command line. The
incoming spots/channels in memory 3 will wait
2 seconds before beginning their fade.
Memory 7 Stored is displayed.
Advertisement
Table of Contents
