Headlight Bulb - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

LIGHTING SYSTEM

12.Headlight Bulb

1. HIGH BEAM & HALOGEN TYPE LOW

• Because the halogen bulb operates at a high

temperature, dirt and oil on the bulb surface re-

duces the bulb's service life. Hold the flange

portion when replacing the bulb. Never touch

the glass portion.

• Do not leave the headlight without a bulb for

a long time. Dust, moisture, etc. entering the

headlight may affect its performance.

1) Disconnect the ground cable from battery.

2) Remove the air intake duct. (When removing the

headlight bulb RH).

3) Remove the battery cover. (When removing the

headlight bulb LH)

4) Tilt the washer tank filler neck. (When removing

the headlight bulb LH)

5) Disconnect the harness connector.

6) Remove the bulb assembly (A) then remove the

high beam. To remove the low beam, remove the

back cover (B), and then go to step 7.

Headlight Bulb

7) Disconnect the harness connector, and remove

2. HID TYPE LOW BEAM

• Do not work with wet hands.

• Because the lighting circuit uses high volt-

age, be sure to confirm that the power supply is

turned off before operation.

• When replacing the bulb, hold the flange por-

tion, and never touch the glass.

• Do not leave the headlight without a bulb for

a long time. Dust, moisture, etc. entering the

headlight may affect its performance.

1) Disconnect the ground cable from the battery.

2) Remove the headlight assembly. <Ref. to LI-14,

REMOVAL, Headlight Assembly.>

3) Remove the back cover.

4) Disconnect the harness connector.