Brake Pipe - Subaru Impreza 2004 Service Manual

Brake Pipe

BRAKE
17.Brake Pipe
A: REMOVAL
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
• All airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the center brake
pipe.
• When removing the brake pipe, make sure
that it is not bent.
B: INSTALLATION
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
• All airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
• Be careful not to damage the airbag system
wiring harness when servicing the center brake
pipe.
• When installing the brake pipe, make sure
that it is not bent.
• After installing the brake pipe and hose,
bleed the air.
• After installing the brake hose, make sure
that it does not touch the tire or suspension as-
sembly, etc.
Brake pipe tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
C: INSPECTION
Ensure there are no cracks, breakage, or damage
on pipes. Check the joints for fluid leakage. If any
cracks, breakage, damage or leakage is found, re-
pair or replace the pipe.
NOTE:
Use a mirror when inspecting low-visible part or
back side.
BR-67