Combination Meter - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

INSTRUMENTATION/DRIVER INFO

4. Combination Meter

1) Disconnect the ground cable from battery.

2) Set the tilt steering at the lowest position. For

steering wheel with telescopic system, pull the

3) Remove the plastic hook (A), and detach the

meter visor.

4) Remove the screws of the combination meter,

and pull on the meter while tipping it towards your-

5) Disconnect the connector in the rear side of

combination meter to remove meter.

• Be careful not to damage the meter or instru-

• Pay particular attention to avoid damaging

the meter glass.

B: INSTALLATION

• Make sure the electrical connector is con-

nected securely.

• Make sure that each meter operates normal-

• When the combination meter of model with

immobilizer has been replaced, be sure to per-

form the registration of immobilizer.

Install in the reverse order of removal.

Combination Meter

C: DISASSEMBLY

1. DISASSEMBLY OF COMBINATION

• Use gloves to avoid damage and getting fin-

gerprints on the glass surface and meter sur-

• Be careful not to apply excessive force to the

• Be sure not to touch the meter indicator nee-

Disengage the tabs (A), and remove the meter

glass assembly (B) and meter visor (C) from the

meter case assembly (D).

2. BULB REPLACEMENT

LEDs are used for all of warning lights and indicator

lights of combination meters, replace the meter

case assembly if faulty.

Assemble in the reverse order of disassembly.