Subaru 2009 IMPREZA Service Manual page 2967

5. Turn Signal Light and Hazard
Light System
A: WIRING DIAGRAM
Refer to "Turn Signal Light and Hazard Light Sys-
tem" in WI section. <Ref. to WI-112, WIRING DIA-
GRAM, Turn Signal Light and Hazard Light
System.>
B: INSPECTION
1. TURN SIGNAL SWITCH
Measure the resistance between turn signal switch
terminals. <Ref. to LI-12, TURN SIGNAL SWITCH,
INSPECTION, Combination Switch (Light).>
2. HAZARD SWITCH
Measure the resistance between hazard switch ter-
minals.
Switch position Terminal No.
OFF
2 and 3
ON
Replace the hazard switch if faulty.
3. TURN SIGNAL AND HAZARD MODULE
Connect the battery and turn signal light bulb to the
module. The module is properly functioning if it
blinks when power is supplied to the circuit.
3 2 1
8 7 6 5 4
Replace the turn signal & hazard module if faulty.
Turn Signal Light and Hazard Light System
4 3 2 1
LI-00799
Standard
1 M or more
Less than 1
LI-00262
LI-7
LIGHTING SYSTEM