Front Fog Light Assembly - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

LIGHTING SYSTEM

15.Front Fog Light Assembly

1) Disconnect the ground cable from battery.

2) Disengage the two clips, and then turn over the

3) Disconnect the harness connector.

4) Remove the upper clip and the lower bolt and

clip, and then remove the fog light assembly.

B: INSTALLATION

Install in the reverse order of removal.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Front Fog Light Assembly

C: ADJUSTMENT

1. FOG LIGHT AIMING

1) Before checking the fog light beam level, be sure

of the following:

• The area around the fog light has not sustained

any accident, damage or other type of deformation.

• Vehicle is parked on a level surface.

• The inflation pressure of tires is correct.

• Vehicle's fuel tank is fully filled.

2) Bounce the vehicle several times to normalize

the suspension.

3) Make certain that someone is seated in the driv-

4) Disengage the two clips, and then turn over the