Subaru 2009 IMPREZA Service Manual page 3110

SECURITY AND LOCKS
5. SECURITY SYSTEM
(1)
(1) Horn
(2) Body integrated unit
(3) Security indicator light
(in combination meter)
(4) Power window main switch
(5) Rear gate latch switch
(5 door model)
B: CAUTION
• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery.
When repairing the audio, control module, etc. which are provided with memory functions, record the mem-
ory contents before disconnecting the ground cable from battery. Otherwise, these contents are erased upon
disconnection.
• When performing a check after disconnecting the battery or restoring from a dead battery condition, per-
form the check after turning the ignition to ON and OFF, then opening and closing the driver's side door a few
times.
• Reassemble the parts in the reverse order of disassembly unless otherwise indicated.
• Adjust the parts to the specifications described in this manual if so designated.
• Connect the connectors securely during reassembly.
• After reassembly, make sure all the functional parts operate smoothly.
• The airbag system wiring harness is routed near electrical parts and switches.
• Do not use electrical test devices on any airbag system wiring harnesses or connector circuits.
• Be careful not to damage the airbag system wiring harness when servicing the ignition key cylinder.
General Description
(4)
(3)
(5)
(2)
(9)
(6) Keyless entry control module
(7) Door switch
(8) Impact sensor
(driver's seat instrument panel side)
(dealer option)
(6)
(6)
(10)
(7)
(8)
SL-6
(9) Horn relay (in main fuse box)
(10) Trunk lid latch switch
(4 door model)
SL-00862