Headlight Assembly - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

LIGHTING SYSTEM

11.Headlight Assembly

• Do not perform work with wet hands.

• The HID headlight uses very high voltages for

the lighting circuit. Make sure that the power is

turned OFF before working.

1) Disconnect the ground cable from battery.

2) Remove the air intake duct. (When removing the

headlight RH).

3) Remove the front bumper face. <Ref. to EI-29,

FRONT BUMPER FACE, REMOVAL, Front

4) Disconnect harness connectors.

5) Remove the five bolts and clip to remove the

headlight assembly.

B: INSTALLATION

Install in the reverse order of removal.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Headlight Assembly

C: DISASSEMBLY

1. HID HEADLIGHT BALLAST

• Do not perform work with wet hands.

• The HID headlight uses very high voltages for

the lighting circuit. Make sure that the power is

turned OFF before working.

• Do not leave the headlight without the ballast

for a long time. Dust, moisture, etc. entering the

headlight may affect its performance.

1) Disconnect the ground cable from battery.

2) Remove the headlight assembly. <Ref. to LI-14,

REMOVAL, Headlight Assembly.>

3) Remove the back cover.

4) Disconnect the harness connector.

5) Remove the harness connector and screws to

pull out the ballast.