Steering Satellite Switch - Subaru 2009 IMPREZA Service Manual

9. Steering Satellite Switch

A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the "AB" section for proper handling of the
driver's airbag module. <Ref. to AB-5, CAU-
TION, General Description.>
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
®
4) Using TORX bit T30 (1), loosen two TORX
bolts which secure the driver's airbag module.
5) Disconnect the airbag module connector on
back of the airbag module. <Ref. to AB-8, PROCE-
DURE, Airbag Connector.>
6) Remove the steering wheel. <Ref. to PS-12, RE-
MOVAL, Steering Wheel.>
7) Remove the screws to remove the lower cover
from steering wheel.
8) Loosen the screws on the backside of the steer-
ing wheel and remove the satellite switch.
Steering Satellite Switch
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the resistance between satellite switch
connector terminals.
®
Volume (+)
Volume (–)
(1)
SEEK (
SEEK (
CC-00018
Volume (+)
Volume (–)
SEEK (
SEEK (
If the result of the measurement is not at the stan-
dard value, replace the satellite switch.
CC-00650
CC-00516
ET-11
1 2 3 4 5 6 7 8
Switch Position Terminal No.
Mute
All OFF 4 and 5
Mode
)
)
Mute ON 4 and 5
ON 4 and 5
ON 4 and 5
Mode ON 4 and 5
) ON 4 and 5
) ON 4 and 5
ENTERTAINMENT
CC-00487
Standard
Approx. 4.7 k
Approx. 22
Approx. 90
Approx. 200
Approx. 360
Approx. 690
Approx. 1.5 k