Table of Contents
Advertisement
Self-test Error Messages
ADDITIONAL OPTIONS AVAILABLE
5000 Series Quick Reference Guide
Self-test diagnostics are run:
•
During the power-on sequence.
•
After initialization using the control panel.
•
After printing.
•
When requested from the host by the ESC Q escape sequence. (See
5000 Series Programmer's Manual for information on escape sequences.)
The error message is used only in the ANSI emulation while using
the serial interface. When an ESC Q escape sequence is received,
the printer performs a self-test and sends the appropriate error
message to the host if a fault is found. DCS = ESC P and ST = ESC \.
See 5000 Series Programmer's Manual for information on the ANSI
emulation and escape sequences.
A complete listing of the options available in this printer can be found in
the 5000 Series User's Manual, Appendix D. These items may be
obtained from an authorized GENICOM distributor, service agent, or
from GENICOM headquarters at the following address:
When ordering, specify description, part or catalog number, and the
quantity desired. See the 5000 Series Programmer's Manual, Appendix D
for the available items.
41
NOTE
GENICOM Corporation
Parts Sales
1 Genicom Drive
Waynesboro, Virginia 22980-1999
1-800-535-4364
FAX: (540) 949-1890
Electronic Bulletin Board: (540) 949-1576
(Check for current printer drivers and the updated replacement
and spare part listings)
GEK-99012
Advertisement
Table of Contents
