Table of Contents
Advertisement
No power.
Power is frequently
interrupted
Control Panel LCD Messages
LCD messages involving troubleshooting are classified into nine numeric code classes (1 through
9) and an additional alphanumeric class. These code classes have no significance to you as a user
of this printer. These class codes are designed specifically for assisting service and repair person-
nel. When reporting problems make note of the error message by code class.
Sep 01
DESCRIPTION
Power switch not turned
on. Switch is not set to
[ I ].
Power cord not properly
plugged into AC outlet or
AC connector on rear of
printer
Voltage of AC power line
not correct.
Printer is defective
Genicom
GENICOM LN45 and Intelliprint mL450 Installation Guide
POSSIBLE
CAUSE
REQUIRED
ACTION
Check power switch. See
"Chapter 1 Unpacking and
Installing Your Printer"
for
Printer" for more information
Set power switch to [ O ] (off)
and plug in power cord firmly.
See
"Chapter 1 Unpacking and
Installing Your Printer"
for more
information.
Verify that AC outlet is rated for
the correct voltage and
amperage of your printer. See
"Chapter 1 Unpacking and
Installing Your Printer"
for more
information.
Turn printer off [ O ], disconnect
power cord from the AC outlet.
See
"Appendix A GENICOM
Customer Support"
to arrange
for a technical support or
service or repair call.
Publication No. GEG-99122
3-3
Advertisement
Table of Contents
Troubleshooting
