Removing The Sas Raid Controller - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 138.
"Enabling SVOM boot watchdog functionality" on page 146
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
9.5.3

Removing the SAS RAID controller

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.5.3.1 Preliminary steps
"Suspending BitLocker functionality" on page 125
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê Remove all external cables from the expansion card to be removed.
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
page 68.
"Removing the system air duct" on page 81
Ê
430
"Updating RAID controller firmware" on page
"Resuming BitLocker functionality" on page 152
Upgrade and Maintenance Manual
"Enabling Option ROM scan" on
Average task duration:
5 minutes
"Opening the server" on
TX300 S8 / RX350 S8
137.