Show Link State Group - Cisco 3020 - Catalyst Blade Switch Command Reference Manual

show link state group

show link state group
Use the show link state group global configuration command to display the link-state group
information.
Syntax Description
number
detail
Defaults
There is no default.
Command Modes
Privileged EXEC
Command History Release
12.2(25)SEF
Usage Guidelines Use the show link state group command to display the link-state group information. Enter this
command without keywords to display information about all link-state groups. Enter the group number
to display information specific to the group.
Enter the detail keyword to display detailed information about the group. The output for the show link
state group detail command displays only those link-state groups that have link-state tracking enabled
or that have upstream or downstream interfaces (or both) configured. If there is no link-state group
configuration for a group, it is not shown as enabled or disabled.
Examples
This is an example of output from the show link state group 1 command:
Switch> show link state group 1
Link State Group: 1
This is an example of output from the show link state group detail command:
Switch> show link state group detail
Link State Group: 1
Upstream Interfaces
Downstream Interfaces : Gi0/3(Up) Gi0/4(Up)
Link State Group: 2
Upstream Interfaces
Downstream Interfaces :
(Up):Interface up
Cisco Catalyst Blade Switch 3020 for HP Command Reference
2-340
show link state group [number] [detail]
Modification
This command was introduced.
Status: Enabled, Up
Status: Enabled, Up
: Po1(Up)
Status: Disabled, Down
:
(Dwn):Interface Down
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
(Optional) Number of the link-state group.
(Optional) Specify that detailed information appears.
(Dis):Interface disabled
OL-8916-01