Show Link State Group - Cisco Catalyst 2960 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

show link state group

Use the show link state group global configuration command to display the link-state group
information.
Syntax Description
number
detail
| begin
| exclude
| include
expression
Defaults
There is no default.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines Use the show link state group command to display the link-state group information. Enter this
command without keywords to display information about all link-state groups. Enter the group number
to display information specific to the group.
Enter the detail keyword to display detailed information about the group. The output for the show link
state group detail command displays only those link-state groups that have link-state tracking enabled
or that have upstream or downstream interfaces (or both) configured. If there is no link-state group
configuration for a group, it is not shown as enabled or disabled.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples
This is an example of output from the show link state group 1 command:
Switch> show link state group 1
Link State Group: 1
OL-8604-03
show link state group [number] [detail] [ | {begin | exclude | include} expression]
Modification
This command was introduced.
Status: Enabled, Down
(Optional) Number of the link-state group.
(Optional) Specify that detailed information appears.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Catalyst 2960 Switch Command Reference
show link state group
2-491