Replacing Processor Heat Sinks; Removing The Processor Heat Sink; Applying Thermal Paste; Installing The Processor Heat Sink - Fujitsu PRIMERGY RX4770 M1 Upgrade And Maintenance Manual

11.5.4 Replacing processor heat sinks

11.5.4.1 Removing the processor heat sink

Ê Remove the processor heat sink as described in section
processor heat sinks" on page

11.5.4.2 Applying thermal paste

Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page
I
If the processor upgrade or replacement kit contains a new CPU heat
sink, a thin layer of thermal compound has already been pre-applied
to its lower surface. In this case, please proceed with section
"Installing the heat sink" on page

11.5.4.3 Installing the processor heat sink

Ê Install the processor heat sink as described in sections
sink and processor" on page 252

11.5.5 Concluding steps

"Installing the mid-brace" on page 239
Ê
"Reassembling" on page 53
Ê
"Connecting the server to the power source" on page 57
Ê
"Switching on the server" on page 58
Ê
RX4770 M1
254.
256.
and
Upgrade and Maintenance Manual
253.
"Installing the heat sink" on page
Processors
"Removing
"Preparing the heat
253.
255