Removing The Rear Cover Sensor Unit; Connector Connecting Status; Tabs Securing Rear Cover Sensor - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
4.2.3.9 Rear Cover Sensor
1. Remove "Paper Guide Assy., M, SP" (p215).
2. Remove the screw securing "Rear Cover Sensor Unit" to the printer frame.
(Refer to Figure 4-27.)
C.B.B. 2x10: 1 pc.
3. Release the tab securing the "Rear Cover Sensor Unit" to the printer frame
and remove "Rear Cover Sensor Unit".
4. Disconnect the connector from the "Rear Cover Sensor".
(Refer to Figure 4-28.)
5. Release the two tabs securing the "Rear Cover Sensor" to the holder and
then remove the "Rear Cover Sensor".
Rear Cover Sensor Unit
Figure 4-27. Removing the Rear Cover Sensor Unit
Disassembly & Assembly
(Refer to Figure 4-27.)
(Refer to Figure 4-29.)
C.B.B. 2x10
Tabs
Disassembly Procedures
Rear Cover Sensor Connector
Figure 4-28. Connector Connecting Status
Figure 4-29. Tabs Securing Rear Cover Sensor
Revision C
Tabs
225