Serial Interface Errors; Print Module Replacement - Genicom GEK-00027C User Manual

SERIAL INTERFACE ERRORS

Strap 16
Disabled
Disabled
Disabled
Disabled

PRINT MODULE REPLACEMENT

GEK-00028C
If the host does not stop sending data when the printer reports busy,
the input buffer will eventually fill to capacity. Any additional data
sent by the host will be discarded and an error condition will exist.
This error may be reported to the operator via GenPtrOpts (Group 1)
strap 16. See "GenPtrOpts" in Chapter 4 and General Printer Options
Group 1 table on page 179 in Appendix G for additional information.
Parity, Framing and UART overrun characters will be replaced in the
data stream with the "*" character.
Type of Error
Parity Error
Framing Error
UART Overflow Error
Buffer Overflow Error
When Strap 16 is enabled, the action performed is the same as Strap
16 disabled, but a message is displayed and printed. The printer is
placed in an off line condition. Press the CLEAR key to continue.
The six print actuator modules are identical. If a replacement module
is temporarily unavailable, rearrange the modules so that the
defective one is located in an area that is least likely to be used.
Relocating the defective module to the far right end of the shuttle
would still allow a full 11-inch line (110 characters at 10 cpi) to be
printed starting at the left.
Display/Print
Message
Parity Error
Framing Error
UART Overflow
Buffer
Overflow
159
Chapter 7. Operation and Maintenance
Action
performed
Replace character
with "*"
Replace character
with "*"
Replace character
with "*"
Lost data after
end of Buffer