Tearoff Options - Genicom GEK-00027C User Manual

TEAROFF OPTIONS

5180 User's Manual
This menu is used to modify the tear off feature settings for this
printer. The TEAROFF function is to position the paper for tear off at
the fanfold perforation; therefore the TEAROFF position is relative to
and dependent on the TOF setting and Form Length setting. The
default TEAR OFF settings assumes that TOF is set to print the first
line at the physical top of the form (just below the fanfold
perforation).
The TEAROFF position can be adjusted up to +/- 2 inches from the
default value at any time while the TEAROFF function is active using
the ↑ up or ↓ down arrow keys on the control panel. The TEAROFF
function is active when the display shows TEAROFF, such as after
depressing the TEAROFF key.
Adjusting the TEAROFF position does not change the TOF position.
However, changing the TOF position does affect the TEAROFF
position. Therefore, the TOF should be set prior to adjusting the
TEAROFF. (See Setting Top of Form on page 34 for instructions.)
The TEAROFF position is saved to nonvolatile storage and is reset to
factory defaults only via the action of the Maintenance | Reset to
Deflts | Total Init menu operation. (See Reset to Deflts on page 138
for instructions.)
1. While in the Set Up menu, press the ◄ (left) or ► (right) menu
browse key until TearOff is displayed in the lower right corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the TearOff
submenu options.
The following describes the TearOff sub-menus and options:
132
GEK-00028C