Interface Menu - Genicom microLaser 210 User Giude

Interface Menu

The Interface Menu provides access to the printer interface settings. Use the following procedure to
enter the interface menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text "Interface Menu" is shown on the second line of the
display.
3. Press the SELECT button to enter the interface menu.
4. Press the NEXT button to move through the submenus: Port, Parallel Setup, and USB
Setup.
5. Use the procedures in the following table to access and change the printer interface settings:
Submenus
Port
This submenu allows you
to choose the type of
interface. The parallel and
USB ports can not be ON
simultaneously.
Parallel Setup
This submenu allows you
to set up the parallel
interface. When the
Parallel port is on, the
USB port is off.
USB Setup
This submenu allows you
to choose set up the USB
interface. When the USB
port is on, the parallel port
is off.
Mar 00
Default Available
Setting Settings
Parallel: Parallel :
On On, Off
USB: USB:
Off On, Off
Interpreter: Interpreter:
Auto Switch Auto Switch
PCL
PostScript 3
Format: Format:
Raw Raw
Normal
Binary
Mode: Mode:
Bidirectional Bidirectional
Standard
Delay Out Delay Out Close:
Close: On
Off Off
Interpreter: Interpreter:
Auto Switch Auto Switch
PCL
PostScript 3
Format: Format:
Raw Raw
Normal
Binary
Genicom
microLaser 210 User Guide 3-9
Interface Menu
Procedure for Changing Setting
1. Press NEXT or PREVIOUS to toggle between
PARALLEL and USB.
2. Press SELECT to save this setting.
1. Press NEXT or PREVIOUS to scroll through the
INTERPRETER, FORMAT, and MODE
submenus.
2. Press SELECT to choose a submenu.
3. Press NEXT or PREVIOUS to scroll through the
settings.
4. Press SELECT to choose and save a setting.
1. Press NEXT or PREVIOUS to toggle between
INTERPRETER and FORMAT submenus.
2. Press SELECT to choose either submenu.
3. Press NEXT or PREVIOUS to scroll through the
settings.
4. Press SELECT to save this setting.
Publication No. GEG-99054