Left Print Ref - Genicom GEK-00027C User Manual

Modify Format

Left Print Ref

Left Print Ref
By IN
Left Print Ref IN
00.0
Left Print Ref IN
00.0
GEK-00028C
Left Print Ref
This menu option is used to set the left print ref. The left print ref
may be set By Inches or By Column.
Use the following procedures for setting the left print ref:
1. While in Modify Format menu, press the ◄ (left) or ► (right) menu
browse keys until Left Print Ref is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Left Print Ref
options. Left Print Ref will be displayed in upper left corner of
LCD.
3. Press ◄ (left) or ► (right) menu browse key and select By IN or By
Column. Press the Select key to select one of these options. The
current setting is displayed in the lower right corner of the LCD.
4. Press the Select key again to modify the setting. Notice the cursor
(underline) is now shown under the first digit. The four menu
browse keys revert to data entry operation. The horizontal ◄ ►
(left or right) keys position the cursor (underline) to the digit to be
changed; the vertical ▲ ▼ (up or down) keys
increment/decrement the selected digit by one.
5. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary.
Note
59
Chapter 5. Using the Set Up Menu