Tcp/Ip - Genicom GEK-00027C User Manual

Expansion1

TCP/IP

TCP/IP
IP Address
IP Address
000.000.000.000
GEK-00028C
TCP/IP
This menu is used to configure the TCP/IP settings, IP Address,
Netmask, Router IP Addr, and Frame Type. These options are user-
specified, check with the network administrator where printer will be
used.
Use the following procedures to set the TCP/IP settings:
1. While in the Expansion1 or Expansion2 menu, press the ◄ (left)
or ► (right) menu browse key until TCP/IP is displayed in the
lower right corner of the LCD.
2. Press the ▼ (down) menu browse key to access the TCP/IP menu
options. TCP/IP is displayed in the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
menu setting is displayed in the lower right corner of the LCD.
Press the Select key to access the menu desired.
4. Press the Select key again to enable or disable a setting option.
The < symbol will immediately follow an enabled TCP/IP setting.
IP Address, Netmask, and Router IP Address are user set options.
5. Pressing the Clear key will exit the current option menu option, so
that selection of another option may be made.
Use the following procedures to use these settings:
1. The option to be set will be displayed in the upper right corner of
the LCD. (The example to the left is for the IP Address setting.)
Notice the cursor (underline) is now shown under the first digit.
The horizontal ◄ ► (left or right) menu browse keys position the
cursor (underline) under the digit to be changed; the vertical ▲ ▼
(up or down) menu browse keys increment/decrement the
selected digit by one.
2. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary. Cycle power
after entries to activate changes.
Note
87
Chapter 5. Using the Set Up Menu