Ca(Rts); Sca(Srts) - Genicom GEK-00027C User Manual

CA(RTS)

Protocol
CA(RTS)
CA(RTS)
Ready/Busy

SCA(SRTS)

Protocol
SCA(SRTS)
SCA(SRTS)
Ready/Busy
5180 User's Manual
This option is used to configure CA(RTS) settings for RS232 serial
type. This is also known as Request to Send.
Option
Ready/Busy
ON/OFFline
Fault
1. While in the Protocol menu, press the ◄ (left) or ► (right) menu
browse key until the CA(RTS) option is displayed.
2. Press the ▼ (down) menu browse key to access the CA(RTS)
options.
3. Press the ◄ (left) or ► (right) menu browse keys until the desired
CA(RTS) option is displayed in the LCD.
4. Press the Select key to enable or disable an option. The < symbol
will now immediately follow the enabled option.
This option is used to configure the SCA(SRTS) settings RS232 serial
type. This is also known as Secondary Request to Send.
Option
Ready/Busy
ON/OFFline
Fault
1. While in the Protocol menu, press the ◄ (left) or ► (right) menu
browse key until the SCA(SRTS) option is displayed.
2. Press the ▼ (down) menu browse key to access the SCA(SRTS)
options.
3. Press the ◄ (left) or ► (right) menu browse keys until the desired
SCA(SRTS) option is displayed in the LCD.
4. Press the Select key to enable or disable an option. The < symbol
will now immediately follow the enabled option.
Meaning
RTS signal is used to reflect if the printer is ready
(able to receive data) or busy (currently unable to
receive data.)
RTS signal is used to reflect the printer is online or
offline.
RTS signal is used to reflect whether a fault
condition exists.
Meaning
STRS signal is used to reflect if the printer is ready
(able to receive data) or busy (currently unable to
receive data.)
SRTS signal is used to reflect the printer is online or
offline.
SRTS signal is used to reflect whether a fault
condition exists.
76
GEK-00028C