Filter Settings; Igp; Bc Density - Genicom GEK-00027C User Manual

Set Up
Select Filter
Select Filter
Serial

FILTER SETTINGS

Set Up
Filter Settings

IGP

Filter Settings
IGP
IGP

BC Density

BC Density
High<
5180 User's Manual
1. While in Set Up menu, press the ◄ (left) or ► (right) menu browse
keys until Select Filter is displayed in the lower right corner of the
LCD.
2. Press the ▼ (down) menu browse key to access the Select Filter
options. Select Filter will be displayed in the upper left corner of
the LCD.
3. Press the ◄ (left) or ► (right) menu browse keys until the filter
desired is displayed in the lower right corner of the LCD.
4. Press the Select key to select the filter option. The < symbol will
now immediately follow the saved filter option.
This menu option configures settings for QMS, IGP, IPDS* and IBM
Format*.
Use the following procedures to use this option.
1. While in the Set Up menu, press the ◄ (left) or ► (right) menu
browse key until Filter Settings is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Filter Settings
options.
* Viewable with SCS or IPDS software installed in printer.
The following describes the sub-menus and options available:
This configures the IGP filter option.
1. While in the Filter Settings menu, press the ◄ (left) or ► (right)
menu browse key until IGP is displayed in the lower right corner
of the display.
2. Press the ▼ (down) menu browse key to access the configuration
settings for IGP.
The following describes the options available:
BC Density
This selects the BC (Bar Code) Density setting for IGP. Low
represents low density, Medium represents double horizontal, and
High represents staggered format.
1. While in the IGP menu, press the ◄ (left) or ► (right) menu
browse key until BC Density is displayed in the lower right corner
of the LCD.
2. Press the ▼ (down) menu browse key to access the BC Density
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
92
GEK-00028C