Lead Polarity; Data Bits - Genicom GEK-00027C User Manual

Inhibit Xmit
Never

Lead Polarity

Serial Setup
Lead Polarity

Data Bits

Serial Setup
Data Bits
Data Bits
7 Bits
5180 User's Manual
2. Press the ▼ (down) menu browse key to access the Inhibit Xmit
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
protocol sub-menu option is displayed in the lower right corner of
the LCD.
4. Press the Select key to enable or disable an option. The < symbol
will now immediately follow the enabled option.
This sub-menu is used to configure lead polarity settings for RS232
serial type. There are five additional sub-menus available.
Type of Signal
Sent High
CD(DTR)
CA (RTS)
SCA (STRS) Signal is active high.
CB (CTS)
CC (DSR)
1. While in the Serial Setup menu, press the ◄ (left) or ► (right)
menu browse key until Lead Polarity is displayed in the lower
right corner of the display menu.
2. Press the ▼ (down) menu browse key to access the Lead Polarity
sub-menus.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
lead polarity sub-menu selection is displayed in the lower right
corner of the LCD.
4. Press the ▼ (down) menu browse key to access setting for the
lead sub-menu. Press the ◄ (left) or ► (right) menu browse key
until the desired setting is displayed in the lower right corner of
the LCD.
5. Press the Select key to enable or disable an option. The < symbol
will immediately follow the enabled option.
This sub-menu is used to configure the number of data bits per
character for serial RS232. There are two settings under the Data
Bits option, 7 Bits or 8 Bits. Set the data bits equal to that of the host
computer.
1. While in the Serial Setup menu, press the ◄ (left) or ► (right)
menu browse key until Data Bits is displayed in the lower right
corner of the display menu.
2. Press the ▼ (down) menu browse key. Data Bits will be displayed
in the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
selection is displayed in the lower right corner of the LCD. Press
the Select key to enable or disable an option. The < symbol will
now immediately follow the enabled option.
Meaning
Low
Signal is active low.
78
GEK-00028C